1. Title : In Enter PUK code screen, some input boxes are not shown 2. Precondition : set PIN lock 3. Tester's Action : Power on - PIN code Lock screen - Enter incorrect PIN code - Enter PUK code screen - Enter new PIN code 4. Detailed Symptom (ENG.) : create pin code/confirm new pin code box can't see by qwerty keypad 6. Expected : All input box will be displayed during entering pin code 7. Reproducibility: Y 1)Frequency Rate : 100% 8. Gaia revision : a03f7b532e9998e646d55f93a0fc03a04d7ca7d9

I’m afraid I don’t understand this bug report. Let’s first make sure we agree on the behavior of the keypad: • when an input box is focused, the keypad shows up; • if needed, the input box is scrolled up so that it can be visible along with the keypad; • when the input box loses the focus, the keypad disappears. Is that what you see? (on this panel and on other panels) Is that a nominal behavior for you? (In reply to leo.bugzilla.gaia from comment #0) > 4. Detailed Symptom (ENG.) : create pin code/confirm new pin code box can't > see by qwerty keypad > 6. Expected : All input box will be displayed during entering pin code I don’t get it. Would you please rephrase? If you mean that all three input boxes should be visible while the PUK code is entered, that’s just impossible: there’s not enough screen estate on the target resolution to show the three inputs along with the header bar and the keypad. If you mean that the panel content isn’t scrolled up when the “Create PIN” and “Confirm PIN” inputs are *focused*, then we have a serious issue, and I’ll get a prepaid SIM card tomorrow to test that.

OK, I got it. STR: • Unagi, latest Gaia-master & Gecko-b2g18 • Settings > SIM security > enable SIM PIN • turn Airplane mode off and on again to trigger the “Enter SIM PIN” dialog • enter a wrong SIM PIN three times in a row to trigger the “Enter PUK code” dialog • enter the PUK code • tab above the “PUK code” input to dismiss the keypad • tab in the “Create PIN” input to show the keypad Expected result: • the keypad shows up and the “Create PIN” input is scrolled up Actual result: • the keypad shows up but the “Create PIN” input is *NOT* scrolled up I’ll have a look ASAP. I’m not sure it should be considered “critical” though: the “Enter PUK code” dialog works fine otherwise (= I could unlock my SIM card with it), it’s just a presentation issue.

(In reply to Fabien Cazenave [:kaze] from comment #6) > • tab above the “PUK code” input to dismiss the keypad > • tab in the “Create PIN” input to show the keypad tap* above the “PUK code”… tap* in the “Create PIN”…

Kaze, would you mind if I take a look at this bug?

Be my guest. :-)

This is probably a duplicate of bug 808610, please re-open if I’m wrong.